Thingiverse
Top Bracket for ASW X2
von awanistatix89
57
Downloads
37
Likes
0
Makes
This is a remix of the top bracket for the Artillery Sidewinder X2 from dukedoks. There are two versions. The "_hole" version has two holes on top to fit those longer rod or precut rod.
This is for the original 8mm rod top bracket. The one I'm using is 10mm rod. Hit me up if you want 10mm top and bottom bracket. Use a longer M5 screw on the top bracket, though I think original screws are fine as well.
The printing orientation is the same as in the dukedoks vid. I have issue with the part being warp at the thinnest edge. So a brim would be nice, though its not crucial anyway. Unless your bed is really out of level.
*Updated 07/02/2024
Added 10mm for both version
This is for the original 8mm rod top bracket. The one I'm using is 10mm rod. Hit me up if you want 10mm top and bottom bracket. Use a longer M5 screw on the top bracket, though I think original screws are fine as well.
The printing orientation is the same as in the dukedoks vid. I have issue with the part being warp at the thinnest edge. So a brim would be nice, though its not crucial anyway. Unless your bed is really out of level.
*Updated 07/02/2024
Added 10mm for both version
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
