Thingiverse
Top Mount Spool Enclosure
von nickodemous
22
Downloads
15
Likes
0
Makes
Keep your filament free of dust. Well, and it looks sweet - make your printer into a Robo Robot! This works with my [Sturdy Top Mount Spool Holder](https://www.thingiverse.com/thing:2758998), though may work with others also.
To use, open the doors slightly to place over your spool (needed because the shape is form fitting) then push the doors back into their closed position. You can track your filament levels through the windows.
Would love to hear what people think or see builds!
**Updates**
2018-04-13 - The gripper feet pictured on each door didn't hold to the sides of the enclosure as well as intended. I've redesigned (see exploded model) to use a clip instead.
2018-05-03 - The door-window in the picture is actually a version I didn't release. It was REAL hard to get the window in and the corners got a little messed up, so I redesigned so the top edge did not overlap the corners. Down side is with the lack of pressure the curvature is lost unless the window is exactl
To use, open the doors slightly to place over your spool (needed because the shape is form fitting) then push the doors back into their closed position. You can track your filament levels through the windows.
Would love to hear what people think or see builds!
**Updates**
2018-04-13 - The gripper feet pictured on each door didn't hold to the sides of the enclosure as well as intended. I've redesigned (see exploded model) to use a clip instead.
2018-05-03 - The door-window in the picture is actually a version I didn't release. It was REAL hard to get the window in and the corners got a little messed up, so I redesigned so the top edge did not overlap the corners. Down side is with the lack of pressure the curvature is lost unless the window is exactl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
