Torch Candle Holder

I wanted to have the feel of walking the halls of some untouched ancient pathway while walking through the house at night and this was a simple design that was effective and gives the vibe I was looking for.

The Torch Top (spikey) portion of the torch was printed at 15% infill with no support.

The Torch Bottom (handle) portion of the torch was printed at 35% for stability reasons. I printed it with the square portion flat down and tree supports for the overhangs at the handle ends.

I super glued the Torch Top to the Torch Bottom to finish the Torch itself.

The Top Wall/Bed Mount is the main mount. I printed it at a whopping 75% infill. I did this to make sure that it would have no issue supporting the combined weight of a candle and the torch itself.
NOTE: You may need to adjust the countersunk portion of the screw holes depending on the size of the screw heads of the screw you use.

I didn't end up needing it and wanted to save from too many holes in my bedpost BUT I i