Thingiverse
Torghast lamp
von dextraise
0
Downloads
0
Likes
0
Makes
I made this lamp in stream (twitch.tv/gentilrex :D ).
I didn't print it yet.
There should be supports on the top part, but the base shouldn't need any.
As I see it, you don't need much infill (not more than 5-10%) as there shouldn't be too much pressure applied to it.
You will need to put LEDs on the bottom part, all around it.
I didn't print it yet.
There should be supports on the top part, but the base shouldn't need any.
As I see it, you don't need much infill (not more than 5-10%) as there shouldn't be too much pressure applied to it.
You will need to put LEDs on the bottom part, all around it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!