Thingiverse
TORQUEBOARDS Motor & Mount Protector
von SpeedSloth
0
Downloads
0
Likes
0
Makes
Designed to protect the motor from bumps and scrapes with the torqueboads motor mount.
Particularly when mounted in reverse config with a shallow angle and low ground clearance.
I printed mine from TPU 100% infill but any hard filament will do the job.
*May not work with 320mm belts as may clash with motor. Confirmed to work with 300mm with clearance. Probably ok if you have longer reversed motor mount.
Particularly when mounted in reverse config with a shallow angle and low ground clearance.
I printed mine from TPU 100% infill but any hard filament will do the job.
*May not work with 320mm belts as may clash with motor. Confirmed to work with 300mm with clearance. Probably ok if you have longer reversed motor mount.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
