Touch ID enclosure (wired and wireless)

SummaryOriginal designWired and wireless models use the same internal parts.No drilling, No glue.A clear path for the sensor ribbon cable.Only one m3 screw is needed.4 printed parts1 x Sensor holder1 x Motherboard tray1 x Case (choose wired or wireless)1 x Back cover (choose wired or wireless)Additional parts needed (link to what I used)1 x m3 screw (Amazon)1 x m3 threaded insert (Amazon)Assembly InstructionsInsert the USB connector into its slot.Push down the motherboard onto the tray.Connect the USB component to the motherboard and place the tray in the enclosure, ensuring it fits around the internal walls.Place the sensor in the center square, making sure the ribbon cable is directed to the opposite side of the USB connector.Slide in the sensor holder to secure the sensor. If the fit is too tight, slide the holder in and out a few times to smooth it before inserting the sensor.Connect the sensor ribbon cable to the motherboard as shown in the photo below.(Wireless units only): Attac