Thingiverse
Touchscreen & Raspberry Pi Cooled Housing
by ElmerPhud
3
Downloads
1
Likes
0
Makes
This is an alternative to the excellent Ender 3 Touchscreen Case & Holder for Raspberry Pi by Tronnic.
Wishing to use a Pi 4 I did not feel the fan blowing on the back of the Pi pcb would provide adequate cooling. I have designed a back to the case, that fitted with a small centrifugal fan, ducts cooling air into the space between the Pi and TFT to take heat away fron the heatsinks.
I used a 24V 4010 fan, but these are also available in 5v and 12v models to suit your setup.
Heatserts are used to secure the fan.
NOTE: Assembly requires that the front housing, with Pi and TFT installed, be installed in the support frame before installing the case back and clip.
Wishing to use a Pi 4 I did not feel the fan blowing on the back of the Pi pcb would provide adequate cooling. I have designed a back to the case, that fitted with a small centrifugal fan, ducts cooling air into the space between the Pi and TFT to take heat away fron the heatsinks.
I used a 24V 4010 fan, but these are also available in 5v and 12v models to suit your setup.
Heatserts are used to secure the fan.
NOTE: Assembly requires that the front housing, with Pi and TFT installed, be installed in the support frame before installing the case back and clip.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!