Thingiverse
Towel Clamp
door muelmx
13
Downloads
14
Likes
0
Makes
Clamp to hold things like towels, clothes or fabric.
Prints lying on front side (see picture) without supports or special settings. I printed it with .2mm layer height and 15% infill.
The magnet version can be loaded (press-fit) with 7 5x3mm round magnets. The non-magnet version can be attached with tape.
For the magnet version and depending on the surface I recommend to use some additional anti slip pads.
Prints lying on front side (see picture) without supports or special settings. I printed it with .2mm layer height and 15% infill.
The magnet version can be loaded (press-fit) with 7 5x3mm round magnets. The non-magnet version can be attached with tape.
For the magnet version and depending on the surface I recommend to use some additional anti slip pads.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
