Thingiverse
Towel Heater Mount
por scootsmcgoots
0
Descargas
1
Likes
0
Makes
Designed for an electric towel heater model type HSK Yenga Badheizkörper für rein elektrischen Betrieb H: 182,4 B: 60 cm.
The original heated towel holder, while looking fancy, creates a giant lever arm for anyone that leans against it (children) that will rip plastic masonry anchors right out of the concrete. This mount gives the towel rack another touch point to the wall. We actually used two. One top and one bottom of the rack.
The bottom piece should be measured with care about its placement to be directly in the middle of one of the desired rung. The towel rack should be removed from the wall for this. Mount the bottom with the dovetail opening facing towards the outside of the rack so the top can later be slid on. Remount the towel rack, and then slide the top over the desired rung. The dovetail will slide in and lock it into place.
The Base uses an M4 flathead screw.
The original heated towel holder, while looking fancy, creates a giant lever arm for anyone that leans against it (children) that will rip plastic masonry anchors right out of the concrete. This mount gives the towel rack another touch point to the wall. We actually used two. One top and one bottom of the rack.
The bottom piece should be measured with care about its placement to be directly in the middle of one of the desired rung. The towel rack should be removed from the wall for this. Mount the bottom with the dovetail opening facing towards the outside of the rack so the top can later be slid on. Remount the towel rack, and then slide the top over the desired rung. The dovetail will slide in and lock it into place.
The Base uses an M4 flathead screw.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!