Thingiverse
Toy Connector Disc
von TaliTuli
4
Downloads
7
Likes
0
Makes
This is based on one of those toy connectors, which connect to each other and can be used to build. If you have issues with tolerance, increase or decrease the height of the model a bit.
Each model should take about 12 minutes with 0.12 mm layer height, and only take 2 grams of filament with 20% infill. Great for test prints, which tend to accumulate after a while so what better use for them than building blocks?
Each model should take about 12 minutes with 0.12 mm layer height, and only take 2 grams of filament with 20% infill. Great for test prints, which tend to accumulate after a while so what better use for them than building blocks?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
