Thingiverse
Toy Hammer
by rodneyk
52
Downloads
38
Likes
0
Makes
Toy Hammer
==========
This is a toy hammer. It was designed to work with a learning set that helps children to use tools. It is a hard model to print due to the shallow overhangs, but it works better than I thought. I printed this out of an experimental material that is a bit like Rubbermade or Tupperware plastic. I would avoid using brittle plastic like PLA, and lean towards using flexible plastics like M3D Tough or Ninja Flex.
Print the head with the top of the hammer on down.
Print the handle on its side.
I provided a couple of versions of the handle and head that I played with while desiging.
The parts are made to snap together, but if you use flexible material you should "weld" the parts together after attaching.
==========
This is a toy hammer. It was designed to work with a learning set that helps children to use tools. It is a hard model to print due to the shallow overhangs, but it works better than I thought. I printed this out of an experimental material that is a bit like Rubbermade or Tupperware plastic. I would avoid using brittle plastic like PLA, and lean towards using flexible plastics like M3D Tough or Ninja Flex.
Print the head with the top of the hammer on down.
Print the handle on its side.
I provided a couple of versions of the handle and head that I played with while desiging.
The parts are made to snap together, but if you use flexible material you should "weld" the parts together after attaching.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
