Toy plane replica

The toy plane has a wingspan of 240mm and a length of 196mm. It can be completely assembled without using glue. All necessary clips and bolts are printed. I even included a small screwdriver.   Use the following settings for the wings: 0,12 layer height, 4 walls, 4 bottoms, 8 tops, 16% gyroid infill The rest can be printed with 0,2 layers, 4 walls, 4 bottoms, 5 tops, 6% gyroid infill. I recommend a brim only for the bolts. See my 3mf for more details and how I positioned the parts on the build plates.   Print the following parts with support: Fuselage (only for the cockpit) Wings (only for th bottom of the threads) Engine (not for the thread) Bolts (only for the head) Struts (use small tree support) Supports (use small tree support) Cockpit (only for the bottom of the thread) Do not use support on the threads.   For assembly follow these steps: put the front cover on the engine screw the engine to the fuselage insert the cockpit into the fuselage and secure it with a short bolt insert the lower wing into the fuselage and secure it with a short bolt insert the rear wing into the fuselage and secure it with a short bolt this is now a bit tricky: insert the middle supports into the fuselage and put the top wing on the supports now put one strut between the lower and top wing insert a long bolt through the lower wing into the strut and screw it to the top wing repeat for the other side clip the propeller and the wheels with the pins to the plane make funny engine noises and play with your new plane