Thingiverse
Toy Submarine
von Tinyhead
63
Downloads
38
Likes
2
Makes
My daughter wanted some toys, so I designed a very basic little cartoon-ish submarine.
The scale is quite large. The one in the picture is 0.5 scale. If left on full scale, it's about 10" tall.
It can be printed with or without supports. If you don't use supports, be sure to have sufficient cooling as some of the angles are pretty steep. The model has thick walls so it's likely you won't need any infill, but 10% will make it a lot stronger.
The scale is quite large. The one in the picture is 0.5 scale. If left on full scale, it's about 10" tall.
It can be printed with or without supports. If you don't use supports, be sure to have sufficient cooling as some of the angles are pretty steep. The model has thick walls so it's likely you won't need any infill, but 10% will make it a lot stronger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
