Thingiverse
TP mask
von Damagedice
1
Downloads
4
Likes
0
Makes
just a quick to print facemask you just slot in some TP and a few rubber bands to make a quick face mask
the print is only 1 mm thick i made it that thin you you could heat it up with a blow dryer and shape it to your face if you want a better fit but you can scale the z if its to flimsy for you
it should fit most standard TP sizes and be able to hold a few sheets if you want i thicker
Just to head off any comments i know this is not ideal but it will offer some protection esp in areas that are out of masks
the print is only 1 mm thick i made it that thin you you could heat it up with a blow dryer and shape it to your face if you want a better fit but you can scale the z if its to flimsy for you
it should fit most standard TP sizes and be able to hold a few sheets if you want i thicker
Just to head off any comments i know this is not ideal but it will offer some protection esp in areas that are out of masks
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
