Thingiverse
Electronics
Go to Model
TP4056 Charging Station
44
Downloads
43
Likes
1
Makes
A little charging station for the TP4056 boards (wich have the micro usb connector and integrated single cell bms).
It fits the KEESIN 18650 cell holders with soldering pins.
Needed hardware:
2-part 5min epoxy glue
two short cables (max. 22AWG)
small clamps or tape
Optional:
two cables or two pin headers for power out / discharging ports (see 1st pic).
----------------------------------------------------------------------------------------
UPDATE: Redesigned the board for better and safer cable management.
Use V2 if you want to use this.
It fits the KEESIN 18650 cell holders with soldering pins.
Needed hardware:
2-part 5min epoxy glue
two short cables (max. 22AWG)
small clamps or tape
Optional:
two cables or two pin headers for power out / discharging ports (see 1st pic).
----------------------------------------------------------------------------------------
UPDATE: Redesigned the board for better and safer cable management.
Use V2 if you want to use this.
SagittariusArtworks also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
