TPU AirSurfer String

This is a TPU string you can print for your AirSurfer, a toy that allows your fingers to surf on the air outside your car window. The string works well when printed with 90A TPU. 95A could probably also work pretty well. Also print with 100% infill.

Print your own AirSurfer here (only the base design is available here on Thingiverse): https://www.thingiverse.com/thing:7343712


How to set up the string with the AirSurfer:

Refer to the gif at the end of the photo gallery of this post to help visualize each step.

Steps:

-Thread the long hole through the small one

-Thread the long hole through the top of the hole in the AirSurfer

-Now thread the loop—which was formed in Step 1—through the long hole

-Tighten, then you're done