Thingiverse
TPU Cane foot
von elhippiesupremo
3
Downloads
5
Likes
0
Makes
A replacement for the rubber foot of a cane.
Made for a cane diameter of about 19mm.
Printed in TPU.
MKII has a checkered texture on the bottom which hypothetically will create more friction with the floor. Recommend experimenting with infill to give a good balance of shock absorption and durability. Fancy support blocking in cura can allow you to create a solid infill zone surrounding the cradle with a bit of spongy gyroid underneath.
Modify it!
Have fun!
Pimp your cane!
Make a pimp cane!
Made for a cane diameter of about 19mm.
Printed in TPU.
MKII has a checkered texture on the bottom which hypothetically will create more friction with the floor. Recommend experimenting with infill to give a good balance of shock absorption and durability. Fancy support blocking in cura can allow you to create a solid infill zone surrounding the cradle with a bit of spongy gyroid underneath.
Modify it!
Have fun!
Pimp your cane!
Make a pimp cane!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!