TPU Pedal Door Stop

This is a very useful model. This TPU door stop works well and is easy to install. The door stop prints in one piece. There are two ways to install the door stop. You can use two small screws to screw it down which is the most permanent installation, or you can use double sided tape which works well with TPU. In the photos I used double sided tape to hold it in place, and I only put tape on the back of the door stop. It works by using the angles and flexibility to let the door slide in effortlessly, but it won't let the door back out unless the pedal is pushed down with your foot. The holes are 3mm to allow for vey small crews to be used. In order for the door stop to work, the bottom of the door must be between 12mm and 20mm above the floor.Boost MeIf this works well for you, please boost the model. Thank you.