Thingiverse
Track Tread- WIP
von joshcurfman
137
Downloads
96
Likes
1
Makes
Work In Progress
--------------------
The goal of this project is to design and produce a fully 3D-printable set of treads for use on future robotics projects.
Each link is 40.5mm wide; the hub is 40mm in diameter excluding the teeth that mesh into the links.
The hub model labeled Adafruit is designed to fit the axle of a small DC gearmotor. The standard hub should be easy to modify for any other motor axle.
The frame is two pieces, and should be easy to print and assemble. All parts (minus motor) are 3D printed.
--------------------
The goal of this project is to design and produce a fully 3D-printable set of treads for use on future robotics projects.
Each link is 40.5mm wide; the hub is 40mm in diameter excluding the teeth that mesh into the links.
The hub model labeled Adafruit is designed to fit the axle of a small DC gearmotor. The standard hub should be easy to modify for any other motor axle.
The frame is two pieces, and should be easy to print and assemble. All parts (minus motor) are 3D printed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!