Slicer Discord
TrackIR Mount – 3D-Druckmodell von Thingiverse Thingiverse

TrackIR Mount

von TiGi123
2 Downloads
2 Likes
0 Makes
Zum Modell
Monitor bracket for TrackIR standard mount, to give a solid fixation. May work for most webcams, too!?

Since monitors became very flat, the standard TrackIR mount doesn't hold the IR camera very good. So, I made a bracket, which is able to give the standard TrackIR mount a proper grip. It should fit for most monitors. I optimized the model a small bit, after I made the photo. So, feedback is appreciated. :-)

The model may work for some webcams, too. Maybe just make it thinner (raise the angle then).
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

TiGi123 veröffentlicht auch auf

18 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen