Thingiverse
Trail Camera 60mm Pole mount
von saabaus
14
Downloads
9
Likes
0
Makes
Pole mount for a Suntek HC-801G Trail Camera.
Two parts to the print to clamp around a 60mm diameter pole.
The halves are joined with 4 bolts around 100mm with nuts.
Camera is attached via a bolt into the base of the camera.
I printed the back half curved side up and the front in its vertical orientation with supports required only for the camera mounting section. There was no need for supports for the bolt head recesses.
Happy Hunting
Two parts to the print to clamp around a 60mm diameter pole.
The halves are joined with 4 bolts around 100mm with nuts.
Camera is attached via a bolt into the base of the camera.
I printed the back half curved side up and the front in its vertical orientation with supports required only for the camera mounting section. There was no need for supports for the bolt head recesses.
Happy Hunting
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
