Thingiverse
Trailer connector holder
door jgrasjo
14
Downloads
4
Likes
0
Makes
This thing was created for cable management of the trailer connector on the car since the hitch I mounted didn't have any features for this
It is made to fit over a 65mm x 65mm square tube, I would think it fits most hitches with a 2" receiver.
When slipped over the tube its secured with a zip tie. I might add a 3D printed clip instead of the zip tie at some point.
I added the fusion 360 file also to make it easier to modify
It is made to fit over a 65mm x 65mm square tube, I would think it fits most hitches with a 2" receiver.
When slipped over the tube its secured with a zip tie. I might add a 3D printed clip instead of the zip tie at some point.
I added the fusion 360 file also to make it easier to modify
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!