Trailer lighting board cable tidy

2x cable tidies that slip under existing light blocks on your trailer board to make storing the cable easier and neater.

Just loosen each light block from the board a little, slip this down from the top side so the print is resting on the upper screw/bolt then tighten back up.

Print it big and flat using the left and right .stl files. These need supports to print, I found trees only touching build plate worked well and broke off easily. When installaing make sure the hoop that slides over the bolts and cable connections has no sharp edges and isn't rubbing any of the lighting cables.

.3mf file uploaded for remixing/tweaking if your light blocks are significantly different from my LED ones. Note that this has the 2 sides -grouped-, not merged. Ungroup to edit, merge to print. When printing the vertical support structures should be part of a single structure, not printing seperately with their own outer layers.