Trailing Arm Conversion Kit for Tamiya Grasshopper

Minor Updates (24.3.18)
1.Fixed some issues in rear arms (too tight bearing hole, fixed to print vertically for better print output)
2.diff bevel gear : reduced thickness (0.5mm) for better fit with gears

============================================================

Final Version : Trailing Arm Conversion Kit for Tamiya Grasshopper

I consider this as the final version of this long lasting 'Trailing Arm Conversion' project for tamiya grasshopper 1/2.

Check my Youtube for detailed instructions to make this kit
part 1 : https://youtu.be/8rX6SD68Og4
part 2 : https://youtu.be/LxsJY6EoNPM

Most of the design weaknesses has been fixed, should replace all of my previous designs.

This kit uses below hardwares :

- Tamiya The Frog Assembly Universal Shafts (53908)
- Tamiya E-Ring Set (50380)
- 1150 Size Ball Bearings (6 or more)

All other parts used in this kit is from stock grasshopper kit. So it is recommended to start with a new grasshopper kit or used grasshopper.