Thingiverse
Train for Rainbow blocks
door Michal_G
6
Downloads
2
Likes
0
Makes
This is a train for rainbow blocks. AFAIK there are two main sizes of the block, larger ones with length of 140mm and smaller ones with length of 100mm.
I make a model for both of them, but print-tested only for the larger one. The tolerances are generous and all edges are chamfered for comfortable handling during play.
There is also and SCAD file for customization.
Additional material: per train wagon:
4x M8 washers
4x M4 wide washer (DIN 9021)
4x M4x8 screws
I recommend to print the main body with brim AND support to have good adhesion of the sticking out parts
I make a model for both of them, but print-tested only for the larger one. The tolerances are generous and all edges are chamfered for comfortable handling during play.
There is also and SCAD file for customization.
Additional material: per train wagon:
4x M8 washers
4x M4 wide washer (DIN 9021)
4x M4x8 screws
I recommend to print the main body with brim AND support to have good adhesion of the sticking out parts
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
