Thingiverse
Trampoline net pole cap
von cjnaz
0
Downloads
1
Likes
0
Makes
These caps fit nicely on the net support poles. The slot on the side is for the net tie strap, and the hole is for a screw to secure the cap in position.
The ID is set at 1.35 inches. Print this in a high strength, high temperature plastic, such as ABS.
A Fusion360 model is included.
The ID is set at 1.35 inches. Print this in a high strength, high temperature plastic, such as ABS.
A Fusion360 model is included.
cjnaz veröffentlicht auch auf
39 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!