Thingiverse
Transfer punch rack
von Schtimpy
12
Downloads
8
Likes
0
Makes
The aluminium rack that my transfer punch set came with was very poorly made: flimsy and the holes did not line up properly.
I drilled out the rivets, and printed spacer pieces to fit between the aluminium plates to provide better support.
Before re-assembing with M4 screws and nyloc nuts, i aligned all of the aluminium plates and re-drilled the holes so that the all align correctly.
Much more sturdy now, and the holes all align now: the aluminium plates are nicely supported.
I drilled out the rivets, and printed spacer pieces to fit between the aluminium plates to provide better support.
Before re-assembing with M4 screws and nyloc nuts, i aligned all of the aluminium plates and re-drilled the holes so that the all align correctly.
Much more sturdy now, and the holes all align now: the aluminium plates are nicely supported.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
