Thingiverse
Transmitter Stick End
0
Downloads
2
Likes
0
Makes
Hey Guys,
This is my first Design so please give Feedback.
Because of a Broken Stick End I decided to make a new one.
It is very Grippy due to its 4 Cones which prevent your Thumbs from slipping of.
Because I designed it for my Transmitter you must check your required Diameter. The Stock Diameter is 4,5mm so you may need to adjust the Scale of the Print in your Slicer Software.
Print the Cones on very low Speed until you got the first few Layers of the Body.
For Installation I recommend just sliding them on and securing them with Superglue.
Have Fun and enjoy your Hobby
This is my first Design so please give Feedback.
Because of a Broken Stick End I decided to make a new one.
It is very Grippy due to its 4 Cones which prevent your Thumbs from slipping of.
Because I designed it for my Transmitter you must check your required Diameter. The Stock Diameter is 4,5mm so you may need to adjust the Scale of the Print in your Slicer Software.
Print the Cones on very low Speed until you got the first few Layers of the Body.
For Installation I recommend just sliding them on and securing them with Superglue.
Have Fun and enjoy your Hobby
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
