Thingiverse
Transtec LaserHD Wallmount
von Stewpid
3
Downloads
0
Likes
0
Makes
This is a 45 degree angled wall mount for the Transtec Laser HD quadcopter frame. The mount lines up with the holes on the bottom of the frame. It will probably work with the non-HD version of this frame as I'm pretty sure the holes on the bottom of the frame are the same. If you use a 20x20 stack I'm not sure if this will work as the small pegs on the mount may interfere with the screws for the stack.
No Supports needed and Low Infill 15%
No Supports needed and Low Infill 15%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
