Trapezoid Block

Steps: Part 1* -First i made a square sketch - I then used the extrude tool with the drat selection on to slope all the sides -i did the same on top in the opposite direction -I then extrude cut a hole in the center in it Part 2* -First i fillited all of the sides connecting the 2 extrudes together -I then cut 2 circular holes (one on top one on the bottom) bigger than the first cut - I finally cut out a square shaped hole on one of the corners Step 3* - I added a border around the top using the extrude tool -Finally i added 4 (1 in each corner) straight slot cuts To the corners of the top