Trash Can Step/Pedal Replacement

This trash can seems to be made under a handful of brands, but a friend managed to kick the corner of their trash can step and broke it off. As a joke, they asked if I could 3D print a replacement for it and so I did.Disclaimer- The friend said the snap-in portion needed a bit of sanding along the length of it before install for smooth operation. I believe this was due to the about of extra walls/layers I added for strength/durability. If you would like to experiment with the print and use less walls/layers than what is suggested below, it *may* fit without needing any sandingSlicer Software/Supports Used: Bambu Studio - **Tree Slim supports were enabled** Additional notes on print settings: Although not likely needed, I changed some settings for the print to make it more durable for long term use- *Wall loops = 5*Bottom Shell layers = 5*Sparse infill Density = 25%*Infill Pattern= GyroidPrinter used: P1S 0.4 nozzleFilament type and amount used: Bambu PETG HF - 54.90g*Any filament can b