Thingiverse
Travel Cribbage Set
door DavidCRobertson
17
Downloads
12
Likes
0
Makes
This is a travel cribbage set inspired by an earlier concept developed by 3DGeneDesigns (thingiverse.com/3dgenedesigns). I ended up starting from scratch and redesigning the entire concept for a few reasons:
- Printing the boards in only one piece led to weakness along the horizontal dimension - the boards were prone to snapping in half. By printing the hole sheets in a different orientation, the entire object is strengthened.
- Also, by printing the holes horizontally, you can layer the print and use two colors easily, creating a nice look to the board.
- I also redesigned the board pieces so they slid out and snapped into position. I thought that was an easier way to fold and unfold the board.
- I also felt like the box could benefit from a snap fit, so I put a hinge and snap latch on the top.
To assemble the cribbage boards, print Board1 and BoardHoles1. Glue them together, matching up the holes. (I like Loctite SuperGlue Ultragel). Do the same with Board2 and B
- Printing the boards in only one piece led to weakness along the horizontal dimension - the boards were prone to snapping in half. By printing the hole sheets in a different orientation, the entire object is strengthened.
- Also, by printing the holes horizontally, you can layer the print and use two colors easily, creating a nice look to the board.
- I also redesigned the board pieces so they slid out and snapped into position. I thought that was an easier way to fold and unfold the board.
- I also felt like the box could benefit from a snap fit, so I put a hinge and snap latch on the top.
To assemble the cribbage boards, print Board1 and BoardHoles1. Glue them together, matching up the holes. (I like Loctite SuperGlue Ultragel). Do the same with Board2 and B
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!