Traxxas Rustler Front Bumper Support

_
Update 2025-01-12
I printed in Sain SMART 95A TPU with 25% Gyroid infill, 3 wall loops.
Will test but the only risk would be that it is too soft (infill percentage).
See new photos.
_

I made this as this was weekend and I could not get a spare part.

I printed this in PLA and it might not to be the best idea as it was short lived.

Hard TPU or nylon should do the work but I have not tried these materials yet.

There are three versions.

Thin one is intended for nylon or hard TPU with zero infill.

Two others are if someone would like to experiment with different infill percentages and wall lines to get it as wanted (hardness).

Anyway, these were my ideas when it was created and this is why it end up that way.

It prints without supports - one support is built into the parts and it needs to be cut off post print.

I am not sure if this even make sense - I created it to solve the problem in that specific moment.

Comments are welcome :)

Bash. Crash. Repeat.