Thingiverse
Treasure chest Version 2 - Working Lock
by Ar0s
3k
Downloads
2.2k
Likes
9
Makes
A vew changes from the Wooden treasure chest, including a new skin and new feet for a more regal looking treasure chest. Other components have remained the same. the texture might be a bit bubbly here and there but wont be visible when painted up.
https://www.thingiverse.com/thing:4634679
Included in the package are build instructions if needed.
If there are problems or parts need to be adjusted slightly please post a comment and ill try to resolve. Same with any ideas for improvement. Feedback is always welcome!
The model is printable without supports except for "Lock Inner Ring". Appart from that it is advisible to print the chest top and bottom with rafts to prevent lifting of the sharp corners.
Files that need multiples:
Chest Foot x4
Hinge Pin x2
Hinge Pin End x2
Ring x2
Ring Holder x2
Parts that need to be glued:
Chest Foot x4 (depending on how tight it fits)
Hinge Pin End x2 (depending on how tight it fits)
Ring Holder
https://www.thingiverse.com/thing:4634679
Included in the package are build instructions if needed.
If there are problems or parts need to be adjusted slightly please post a comment and ill try to resolve. Same with any ideas for improvement. Feedback is always welcome!
The model is printable without supports except for "Lock Inner Ring". Appart from that it is advisible to print the chest top and bottom with rafts to prevent lifting of the sharp corners.
Files that need multiples:
Chest Foot x4
Hinge Pin x2
Hinge Pin End x2
Ring x2
Ring Holder x2
Parts that need to be glued:
Chest Foot x4 (depending on how tight it fits)
Hinge Pin End x2 (depending on how tight it fits)
Ring Holder
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
