Slicer Discord
Tree Steps Strap On, ROS – 3D-Druckmodell von Thingiverse Thingiverse

Tree Steps Strap On, ROS

von PSomeone
186 Downloads
122 Likes
3 Makes
Zum Modell
Tree Steps Strap On, ROS

This is NOT, I REPEAT NOT A RATED CLIMBING DEVICE, any use is deemed an act of accepting risks or injuries associated with this design and use.
First the disclaimer: DO NOT USE WHILE STUPID, if you are stupid well there's no hope for you sorry, DO NOT USE THIS DESIGN, I hope you have someone that will watch out for you!
SERIOUSLY ALWAYS HAVE PROPER SAFETY GEAR (IE. HARNESS and CLIMBING RATED SAFETY EQUIPMENT), Use at your own risk, this is not a life saving piece of equipment, it is a step that you are going to be using at height strapped to a tree holding a weapon, let the sink in before use. Always check your equipment thoroughly before use, delamination, cracks, discoloration, ect... can all be signs part may fail, that being said it may fail randomly do to bad material or print issues. Using this design you assume all responsibility for your self and any injury's that may be sustained during use (IF YOU DO NOT PLEASE MOVE ON, DO NOT TRY MY DESIGNS)

Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen