Trekking pole mod

**A small knob to put on top of trekking pole when/if used as a tent pole.**

*A short story......*

Last summer I went on a hiking trip with a friend, sporting my newly-acquired ultra-light pyramid tent. This tent uses a trekking pole as a tent pole, – a smart idea, if it had not been for me never having needed nor used one before, and therefore forgetting to take one with me on the trip. How that went is a story for another time :-)

However, while testing the setup before leaving, I was concerned about the trekking pole’s sharp end, which I HAD to use on top because I would have to slide the inner tent guide and the support guideline over this (see picture #2).

But, putting the outer shell on top of the small, sharp end would probably tear the fabric, so as a solution for that first trip I found a plastic thingy to put in between the pole and the outer shell to solve the immediate problem.

With a brand new 3D printer in the house, however, I decided to try to make a mod