MakerWorld
Sculptures
Zum Modell
Triceratops Skull
164
Downloads
148
Likes
48
Makes
Hi guys, hope you like this new Triceratops skull:) Feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support. I usually grab the support rather close to the connection, slightly wiggle it around to loosen it before pulling it off:) If you would like to sell prints of my models check out my commercial license my Patreon: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
