Triceratops Skull

I made this skull for a dinosaur-loving friend of my wife. The design is modeled after the MakerBot "T-Rex Skull" http://www.thingiverse.com/thing:308335. I went so far as to steal the T-Rex support base and rod. The base was modified to rotate the rod 180 degrees and emboss the name "Triceratops" on it. The rod is the same as the T-Rex.

The skull was a very involved conversion of the skull from the Triceratops skeleton model from the "Animal Gait Simulation Laboratory" web site at http://www.animalsimulation.org/page3/styled-11/. I may convert the entire skeleton at some point but for now, just the skull.

I've designed support into the Skull and Jaw so no support generation should be needed. However, you will need to let your slicer create a brim if you have any kind of bed adhesion issues. Some finishing with an XActo knife will be required to finish it out after printing. You may need to "adjust" the diameter of the jaw pivots or rod inserts by taking a slight amount o