Trick or Treat

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 7PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Silver Transmission Distance: 0.5PLA BambuLab Basic Beige Transmission Distance: 8This print uses 8 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #5 (0.48mm) swap to RedAt layer #8 (0.72mm) swap to OrangeAt layer #11 (0.96mm) swap to YellowAt layer #15 (1.28mm) swap to BlackAt layer #19 (1.6mm) swap to Blue GrayAt layer #21 (1.76mm) swap to Jade WhiteAt layer #23 (1.92mm)