Tricorder (TOS) - Handheld Sensor/Scanner

This handheld sensor/scanner is made to go with the TOS Tricorder by The Wand Company. The Wand Company included inserts for the storage section to hold a sensor, but does not make a sensor at this time.This is not made to match the prop used on the show, but to fit properly in the Tricorder from Wand. https://www.thewandcompany.com/tricorder/The model is in three pieces, the sensor end, the handle, and the end cap. An earlier version had 4 pieces which had to be glued, but this version has threads for each piece to fit snugly in the corresponding piece. Each piece is on a separate plate, so that a different color may be used, and an AMS would not be required (and even with an AMS, it cuts waste and saves time to print as 3 pieces).The latest version has a sensor component - version 8, this is used with version 7 handle and end cap. The sensor v8 is shorter, improving fit and reducing possibly of getting hung up in the device (version 7 was much more snug). v8 also adds a fillet top ed