Thingiverse
Trifecta Cooling Fan Duct
16
Downloads
16
Likes
0
Makes
Re-designed from the ground up - inspired by Madau3D's **Ductinator** - I present the Trifecta Fan Duct for 3 fans (40 mm), for the Ender 3 / CR10 for a custom mount that goes on a MG12H linear rail block.
This comes with a little standoff block that you can mount the BLTouch onto on the back of the custom mount. Timing belts goes through the small slits in the top on each side.
This comes with a little standoff block that you can mount the BLTouch onto on the back of the custom mount. Timing belts goes through the small slits in the top on each side.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
