Thingiverse
Triforce Bracelet
door Nitrex88
104
Downloads
84
Likes
1
Makes
Simple slide-on bracelet with triforce insert. It is scaled to fit my own wrist snugly (with my arm sticking straight in front of me and my palm facing down, my wrist is approximately 60mm from left to right and 45mm from top to bottom). You will probably need to scale the bracelet up or down to fit your wrist. Scale uniformly in all axis (to keep the triforce insert triangular), and don't forget to apply the same scale to the triforce. The triforce is designed to snap perfectly into insert (you may need to scale it up or down if your printer dimensions are a little off).
The bracelet should be printed at 0.2 layer height or lower with no infill (to give it some flex) and 2 shell perimeters (I used a 0.4 nozzle). The triforce should be printed at 0.1 layer height since it is slightly curved (to match bracelet curve), and I printed it at 100% infill. I printed this in Hatchbox wood PLA and some random unbranded orange/yellow PLA (see post-processing section below for wood stain)
The bracelet should be printed at 0.2 layer height or lower with no infill (to give it some flex) and 2 shell perimeters (I used a 0.4 nozzle). The triforce should be printed at 0.1 layer height since it is slightly curved (to match bracelet curve), and I printed it at 100% infill. I printed this in Hatchbox wood PLA and some random unbranded orange/yellow PLA (see post-processing section below for wood stain)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
