Trigger wall mount for 3D printed firearm replicas

I have a few 3D-printed replica guns I'd like to wall mount, but I could not find any wall mounts that I liked, so I created one that allows the gun to be displayed at any horizontal angle you want.There are two mounting holes, so you can get the angle suitable with one screw and then secure it with the second screw.I have found one screw to hold the mount (and model) just fine. The screw countersink is 9mm and the screw opening hole is 5mm.NOTE: A few people have messaged why the print is in the orientation it is and not lay on the back with the legs in the air.Simple answer: strength. In the recommended orientation the layer lines go around the legs, if printed on it's back the layer lines would go across the legs, making them easy to snap. Much, much stronger in the original (intended) way. Thank you. :)