Slicer Discord
Trinket Bottle – 3D-Druckmodell von Thingiverse Thingiverse

Trinket Bottle

14 Downloads
16 Likes
0 Makes
Zum Modell
When printed please take time to sand down or file down the edge of the vial, not the lid, just the vial's outer edge because if you try to put it together and close it it will lock on you because when printing 3D the lines may be sticking out(you can hit up the inner of the lid if you really need too)...the fraction sticking out is micro, but will lock the lid on and will be hard to remove because the measurements were so on point...so please use sand paper or a file to take a bit off the rough edges and enjoy stashing away for the trip ;)...
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen