Tripod GoPRO

this is an adjustable tripod for a GoPro Camera.
It's all printable without support material.

I made the legs in 2 pieces ("poot boven.stl" & "poot onder.stl") because my print area isn't big enough.
afther you printed te legs, you can glue them together (there's a triangle gap provided).

the assembly of the leg can slide in the leg holder ("poot houder.stl")
if you are lucky en it is stuck, use a small hammer and smash it gently in the leg holder groof. otherwise when the fitting is a little bit loose, use some glue (it depends how correct your printer is).

to assembly the gopro holder ("goprohouder.stl") with the lengthening rod ("verlengtstuk goprohouder"), use a hammer and smash them in eachother
!!!!! WATCH OUT that the triangle are in one line)!!!!!!

afther this you can just mount your gopro on the tripod and adjust the height with the small triangle stick("hoogte staaf.stl")

my first opinion is that it's maybe better to make the same connection figure for the