Tripod phone mount

I needed a support to place my cell phone on the tripod and after not finding any that made me feel confident I decided to design my own.

Some things to take into account is that the support has a built-in tripod thread, since in Spain it is quite difficult to find 1/4 inch nuts. Also an 8mm M3 screw is needed to attach the wheel to the threaded rod.

[Check it out on PrusaPrinters](https://www.prusaprinters.org/prints/63151-tripod-phone-mount)


##Print instructions
- Recommended 0.2mm layer height.
- All parts should be printed in the default orientation for best results.
- It is recommended to print the rod with a brim of 3-4mm.
- The bottom part contains a 0.2mm layer on top of where the wheel is located to allow for unsupported bridging. This layer must be cut once the part is printed.
- No support needed.



##Hardware
- M3 x 8mm screw