Thingiverse
Tripod Quick Release Adapter
von zaZenOmDesigns
0
Downloads
0
Likes
0
Makes
Tripod quick release adapater for small 27mm square tripod quick relese to fit on an old heavy duty 44x67mm VHS recorder tripod quick release plate.
This is my first thing. I made this so I can easil swap my Canon Camera from a smaller tripod to an old heavy duty one I had (circa 1990 I think). It was used for VHS recording so the plate area was huge (obviously) for a camera.
I printed with PLA using a raft to get a clean bottom. Raft may not be necessary. No supports necessary for this.
This is my first thing. I made this so I can easil swap my Canon Camera from a smaller tripod to an old heavy duty one I had (circa 1990 I think). It was used for VHS recording so the plate area was huge (obviously) for a camera.
I printed with PLA using a raft to get a clean bottom. Raft may not be necessary. No supports necessary for this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!