Thingiverse
Tripod
by ouis_
2
Downloads
6
Likes
0
Makes
I have designed a camera tripod with 1/4" mount. I tested it with a load of approx. 4 kg.
When unfolded, the radius is approx. 25-30 cm with a height of 15 cm, so that the camera is stable and dry on grass, for example. When folded up, the radius is 10 cm and the height is 25 cm.
In order not to be overlooked at night, six 5mm LEDs light up in every direction. I used RGB, but white LEDs are also powered by 3V and can be operated with a CR0232 battery without the need to solder in resistors.
It has a guide for a rubber band for transportation and holes for carabiners.
On the top are three 5x5mm recesses for magnets to hold camera equitment.
Have fun with the design, if you have any suggestions for improvement, please write them in the comments.
When unfolded, the radius is approx. 25-30 cm with a height of 15 cm, so that the camera is stable and dry on grass, for example. When folded up, the radius is 10 cm and the height is 25 cm.
In order not to be overlooked at night, six 5mm LEDs light up in every direction. I used RGB, but white LEDs are also powered by 3V and can be operated with a CR0232 battery without the need to solder in resistors.
It has a guide for a rubber band for transportation and holes for carabiners.
On the top are three 5x5mm recesses for magnets to hold camera equitment.
Have fun with the design, if you have any suggestions for improvement, please write them in the comments.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
