TRMNL 7.5" DIY Wall Frame

A thin frame to hang your TRMNL 7.5" DIY Kit on the wall. I opted to hide the buttons/power, and to not use the screen extension cable. I minimized the bezels and made it as thin as possible (13mm). It hangs on the wall with french cleats for easy hanging and maximum adjustability. It prints without support. There is no additional hardware needed, though you can use a 4mm M3 bolt with a washer instead of the plug to hold the control board if you'd like. The backing plate snaps in and is held in place with built in springs. There are two versions: with and without a USB wire guide/hole. The usb wire guide assumes a cable of roughly 3.75mm diameter. Without the wire guide is cleaner if you're going to run on battery. Here is the onshape design if you want to make your own adjustments.