Tron Chess Set Open Display box

I designed this display box to compliment my Tron themed chess set and chess board. This prints in 3 pieces: one each for each side of chess pieces, and then the center sections which has the slot for the four chess board pieces. When i printed it, the fit was VERY snug, so snug that i didn't even need any glue, though with different tolerances on different printers, your mileage may vary. Also, the slots for the pieces are also very snug, they're friction fit. They hold the pieces very tightly, such that they are completely immobile once slotted into place. It just requires a bit of force to insert/remove the pieces from their slots. I originally tried to design a box/lid to go around this display box, but i had troubles printing it, and my wife figured it looked good without a lid, so there you go. Note, I printed this with a 0.6mm nozzle, but you'd probably be fine with a 0.4mm nozzle. Boost Me